3Com 10014299 manual Configure RouterC

DCC Configuration Examples 735

[Router-Bri0]dialer bundle-member 1

[Router-Bri0]dialer bundle-member 2

[Router-Bri0]link-protocol ppp

[Router-Bri0]ppp authentication-mode pap

2Configure RouterB:

[Router] dialer-rule 2 ip permit

[Router] local-user usera password simple usera

[Router] interface dialer 0

[Router-Dialer0]ip address 100.1.1.2 255.255.255.0

[Router-Dialer0]undo dialer enable-circular

[Router-Dialer0] dialer bundle 1

[Router-Dialer0]dialer number 8810148

[Router-Dialer0] dialer user usera

[Router-Dialer0] dialer-group 2

[Router-Dialer0]ppp authentication-mode pap

[Router-Dialer0]ppp pap local-user userb password simple userb

[Router-Dialer0] interface bri 0 [Router-Bri0] undo dialer enable-circular

[Router-Bri0]dialer bundle-member 1

[Router-Bri0]link-protocol ppp

[Router-Bri0]ppp authentication-mode pap

3Configure RouterC:

[Router] dialer-rule 1 ip permit

[Router] local-user usera password simple usera

[Router] interface dialer 0

[Router-Dialer0]ip address 122.1.1.2 255.255.255.0

[Router-Dialer0]undo dialer enable-circular

[Router-Dialer0] dialer bundle 1

[Router-Dialer0]dialer number 8810148

[Router-Dialer0] dialer user usera

[Router-Dialer0] dialer-group 1

[Router-Dialer0]ppp authentication-mode pap

[Router-Dialer0]ppp pap local-user userc password simple userc

[Router-Dialer0] interface bri 0 [Router-Bri0] undo dialer enable-circular

[Router-Bri0]dialer bundle-member 1

[Router-Bri0]link-protocol ppp

[Router-Bri0]ppp authentication-mode pap

DCC Application The local router is connected to the remote end via two ISDN BRI interfaces.The Providing MP Binding traffic threshold must be set to distribute the traffic. Thus, the bandwidth

resources can be allocated according to the actual traffic. The maximum available bandwidth is specified.

As shown in Figure 234, the ISDN BRI interfaces on RouterA and the ISDN PRI interface on RouterB are connected through an ISDN network. RouterA must adopt resource-shared DCC to call RouterB, and RouterB adopts circular DCC to call RouterA. The addresses of RouterA and RouterB are 100.1.1.1 and 100.1.1.2, respectively.