3Com 10014299 Display and Debug Bridge, Typical Bridge Configuration, Display and debug bridge

		Display and Debug Bridge 307
Table 349 Configure bridge on VLAN
	Operation	Command
	Configure the bridge-set on the sub-interface	bridge-set bridge-set
	of VLAN

Display and Debug Bridge

Perform the reset, display and debugging commands in all views.

Table 350 Display and debug bridge

Operation	Command
Clear the statistics of access list rules	reset acl counters [ acl-number]
Clear the entries of all the bridge-sets or	reset bridge [ bridge-set]
specified groups in the forwarding database
Clear the statistics of Spanning Tree	reset stp statistics
Clear the traffic statistics of bridge-set on the	reset bridge traffic
interface
Display the states of all the bridge-sets	display bridge-set [ bridge-set ]
Display the information in the bridge	display bridge information
forwarding database
Display the state and statistics of STP	display bridge spanning-tree
Display the static data of bridge-set traffic on a	display bridge traffic
port
Display the routing and bridging configuration	display bridge bridge-set
on each interface	bridge-template
Display link set configuration of the specified	display bridgebridge-setlink-set
bridge set.
Enable bridge-set debugging	debugging bridge
Enable the spanning-tree protocol debugging	debugging stp { error event
	packet }

Typical Bridge Configuration

Transparent Bridging Multiple LANs

I. Networking Requirements

Suppose that there are several PCs located on the Ethernet segment LAN1 of a building's floor and several PCs and servers on the Ethernet segment LAN2 of another floor of the building. It is required to build the transparent bridge between these two LANs.