Ricoh AP1400/AP2000 manual Configure in Bindery Mode with Pconsole, Available Options

Emulation mode, the server must have Bindery Context. Perform the following steps to confirm the server has Bindery Context:

1.Go to the 4.x server and at the system console type: load install

2.Select Maintenance/Selective Install from the menu.

3.Select NCF Files Options from the menu.

4.Select Edit AUTOEXEC.NCF from the menu.

5.Search the file to see if you have a statement similar to the following included:

SET BINDERY CONTEXT=0U=ENG

Where =0U=ENG is an example of a name for the file server context. Use your own file server context in place of =0U=ENG.

6.At the console prompt, type the SET BINDERY CONTEXT statement that you entered in the AUTOEXEC.NCF file.

Note: The command at the console prompt takes effect immediately. The definition

in the file takes effect when the server is shut down and then restarted.

4.2.2Configure in Bindery Mode with PCONSOLE

Once you confirm the server has Bindery Context, use the following procedures to configure the Network Interface Board.

1.Log into the network as ADMIN.

2.Type PCONSOLE and press the ENTER key.

The following screen appears.

Available Options

Print Queues

Printers

Print Drivers

Quick Setup

Change Context

3. When the Available Options menu appears, press the F4 key (for the Bindery Mode).

Note: If you receive a message asking you to login to a server with Bindery connections, the server you are attached to does not have Bindery Mode enabled. Follow the procedures in 4.2.1. Confirm Bindery Context or log onto a server with Bindery Services activated.

4.From the Available Options screen, select Quick Setup and press the ENTER key.

5.Use Quick Setup to connect your print server, print queue and printer correctly. You can modify these later if you need to.

6.Select Print server and press the F8 key to modify the entry.

Chapter 4 - 6