Ricoh AP1400/AP2000 manual Setting Up the IP Parameters, Press Menu, Press Enter, Escape

Configuring the Printer for the Network with the Operation Panel

Setting Up the IP Parameters

After installing the optional network interface board, configure it for the network using the printer's operation panel.

Reference

⇒P.16 “Type 1 Printer: Installing the Network Interface Board Type

3 2000”

⇒P.22 “Type 2 Printer: Installing the Network Interface Board Type 2000”

A Press {Menu}.

The following message appears on the panel display.

Main Menu: j

Job Control l

B Press {T}{U} until the following message appears.

Main Menu: j

Host Interfacel

C Press {Enter}.

The following message appears on the panel display.

Host Interface:j 1.Printer Lang.l

D Press {T}{U} until the following message appears.

Host Interface:j 1.Network Setupl

E Press {Enter}.

The following message appears on the panel display.

Network Setup: j 1.IP Address l

F Press {Enter}.

The current IP address appears on the panel display. A pointer (k) blinks on the value to be specified.

IP Address: jld# 000.000.000.000

G Specify the first (leftmost) 3 digits of the IP address using {U} {T}. Use {U} to increase a value, and {T} to decrease.

IP Address: jld# 100.000.000.000

H Press {Enter}.

Apointer (k) moves to the second 3 digits.

Note

❒Before pressing {Enter}, you can return the pointer (k) to the pre- vious (left) 3 digits by pressing

{Escape}.

❒If you press {Escape} when the pointer (k) is on the leftmost 3 digits, the specified IP address is canceled and you can return to the previous panel display.

I Repeat steps G and H to specify the rest of the digits of the IP ad- dress.

J Check if the pointer (k) is at the rightmost digit, press {Enter} to

26