Ricoh AP1400/AP2000 manual Where to Place the MAP, How to Install MAP, Using the MAP Program

3.1Where to Place the MAP

The utility can be installed on any workstation hard drive or network drive.

3.2How to Install MAP

The Management Access Program must be installed from Windows 95/98 or NT 4.0, it CANNOT be installed from DOS or Windows 3.1x.

Use the following procedures to install:

1.Start Windows on your PC or workstation.

2.Insert the supplied CD-ROM into the CD-ROM drive.

3.Select RUN from the Start menu.

4.At RUN, type <Drive>:\MAP\SETUP (where <Drive> is your CD-ROM) and click on the [OK] button.

5.Read the information on the MAP setup program screen.

èClick on [Cancel] to quit setup and then close any programs you have running.

èClick on [Next] to continue with the setup program.

6.Identify a path for the program. The path default is C: \Program Files\MAP. You can change the path or use the default. The installation begins.

3.3Using the MAP Program

When you start MAP program from the Start menu, the program will automatically enters Microsoft Internet Explorer, Netscape Navigator, or your default browser and prompt you with a list of IPX print servers listed by their SAP identification and IP print servers by their IP addresses.

Click on the URL of the unit you want to configure to access the unit’s HTTP Server. The program will setup a link to the print server and obtain HTML code describing the home page. Once the HTTP Server home page appears, you can configure or reconfigure your unit.

3.4Configure the MAP Program

Once you install the program, you can Configure MAP to look for IP-based Printer Servers, IPX-based Print Servers and the maximum number of hops to serarch for IP-based Print Servers. The default hop count is 2.

The hop count number determines how many subnetworks the program will search to find units. An entry of 0 on the screen searches only the current subnet. An entry of 2 would

Chapter 3 - 2