Ricoh AP1400/AP2000 manual Removing Misfed Paper, 110

Troubleshooting

Removing Misfed Paper

When a paper misfeed occurs, an error message appears on the panel display. The procedure you should follow to remove the misfed paper depends on the location of the misfeed, which is indicated on the panel display.

RCAUTION:

•When removing misfed paper, do not touch the fusing section because it could be very hot.

Important

❒Check the following points if paper continues to misfeed.

•Make sure that the setting of the paper size dial matches the size and feed direction of the paper loaded in the paper tray.

•If the friction pad or the paper registration roller is dirty, clean it.⇒ P.117 “Cleaning the Friction Pad”

•Make sure that the toner cartridge is set correctly.

❒If misfeeds persist, contact your sales or service representative.

❒Do not leave any torn scraps within the printer.

Note

❒Type 1 Printer illustrations are used in this section.

❒Please refer to the inside of the front cover of this manual to confirm which printer (Type 1 Printer or Type 2 Printer) you have.

❒When opening the front cover, you can find two brown levers (fusing unit lock levers) and two blue levers (pressure release levers). It is not necessary for you to use the brown levers when removing the misfed paper. Only use the blue levers (pressure release levers). See P.3 “Type 1 Printer: Interior” and P.6 “Type 2 Printer: Interior” for the positions of these levers.

10When “Remove Misfeed: Front Cover&Tray” Appears

Note

❒You can apply this procedure for both the standard and optional tray including a tray with the enve- lope feeder.

❒To reset the misfeed condition, open and close the front cover.

A Pull out the paper tray gently not to tear the misfed paper, and re- move misfed paper.

TS3Y200E

110