Ricoh AP1400/AP2000 manual 2 lpd/lpr Printing, Arp -s 192.9.200.200 040c800ff

print server with a name of printfast and an IP address of 192.9.200.200 has the following entry:

192.9.200.200 printfast

5.Add an entry to the arp cache for the Print Server's IP address and Ethernet address. For example:

arp -s 192.9.200.200 0:40:c8:0:0:ff

6.Check the printer to see that the Print Server is connected to the network. Turn on the printer.

7.Send a ping command the Network Interface Board to verify it is running on the network. For example:

ping 192.9.200.200 or ping printfast

The Network Interface Board will not respond to this ping command but it will read its IP address from the packets.

8.Turn the printer off and back on again and then send the ping command again to verify that the print server obtained its IP address. If the Print Server has the address, the result is a confirmation message:

192.9.200.200 is alive

9.Remove the entry from the arp cache using the following command. Specify the Print Server either by its IP address or by its name. For example:

arp -d printfast

7.4.2lpd/lpr Printing

lpd/lpr is an implementation of the standard UNIX line printer daemon which lets you print across a TCP/IP network without the need to install software on your workstation with all filtering and banners done by Network Interface Board. Remote printing uses the same commands (lpr, lpq, lpc) as local printing.

The process begins when the lpr call finds a printer on a remote system by looking at the remote (rm) entry in the /etc/printcap file for that printer. lpr handles a print job for a remote printer by opening a connection with the lpd/lpr process on the remote system and sending the data file (followed by the control file containing control information for this job) to the remote system. The printer-based lpd then filters the data and prints the job according to information contained in the control file and its own printcap file.

Network Interface Board lpd recognizes the format of a certain printer emulations and filters the data, if possible, so it can be printed on the printer type you specify. You can indicate to the Network Interface Board lpd what type of printer is attached to by either:

1.Accepting the default port setting (PCL, PostScript and other), or

2.Changing the listed emulations via the Telnet or the HTML pages accessed by MAP or a Web Browser utility.

The following sections give specifics lpd/lpr setup instructions for various systems.

Chapter 7 - 15