Ricoh AP1400/AP2000 manual Printing the Test, Config. Press Enter Key

Replacing Parts

Printing the Test Page

You can confirm that the printer works properly by printing a test page (configuration page).

A Load paper with the print side up

2 into the paper tray. While lifting the front side of the tray, place the paper tray into the printer. Then, slide it into the printer until it stops.

TS3M250E

Note

❒If you have optional paper trays, repeat the above proce- dure for those trays.

B Move the printer to the place where it was installed. If you have the optional paper feed unit(s), place the printer securely on the unit(s).

C Insert the plug of the power cord securely into the wall socket. Turn the printer's power switch on.

D Print the test page following the procedure below:

APress {Menu}.

The following message appears on the panel display.

Main Menu: j

Job Control l

B Press {U}{T} until the follow- ing message appears on the panel display.

Main Menu:	j
List Print	l

CPress {Enter}.

The following message appears on the panel display.

List Print: j 1.Config. Page l

DPress {Enter}.

The following message appears on the panel display.

Config. Page:

Press Enter Key

EPress {Enter} .

In a short time, the test printing will start.

E If you can complete the test print- ing completely, turn off the print- er's power switch.

Note

❒If you cannot complete the test printing completely, confirm that all of the parts are installed correctly referring to the men- tioned procedures.

F Attach the interface cable to the interface connector of your print- er. Turn on the printer's power switch.

10