Ricoh AP1400/AP2000 manual Register the IP address you speci- fied, Press On Line

Setting Up the IP Parameters

register the IP address you speci- fied.

The following message appears on the panel display.

Network Setup: j 1.IP Address l

K Press {T}{U} until the following message appears.

Network Setup: j 2.Subnet Mask l

L Press {Enter}.

The current subnet mask appears on the panel display.

Subnet Mask:jld# 255.000.000.000

M Specify the subnet mask using the same procedure for specifying the IP address.

N Check if the pointer (k) is at the rightmost digit, press {Enter} to register the subnet mask you specified.

The following message appears on the panel display.

Network Setup: j 2.Subnet Mask l

O Press {T}{U} until the following message appears.

Network Setup: j

3.Gateway l

P Press {Enter}.

Gateway jld# 000.000.000.000

Q Specify the gateway address us- ing the same procedure for speci- fying the IP address.

R Check if the pointer (k) is at the rightmost digit, press {Enter} to register the gateway address you

specified.3 The following message appears on

the panel display.

Network Setup: j

3 .Gateway l

S Press {On Line}.

The panel display returns to the ready condition as follows:

Ready

T Turn the printer's power switch off and on.

The current gateway address ap- pears on the panel display.

27