Ricoh AP1400/AP2000 manual 103, Placing the Toner Cartridge

Error & Status Messages on the Operation Panel

Messages	Description	Comments
Reset Tray(s)	The tray on the paper feed-	Set the tray correctly. The printer
Correctly	ing path is not set correctly	will re-start printing automatical-
	when the printer receives	ly.
	the print job.
Tray XX	Paper runs out in tray XX.	Load paper.
Add Paper		⇒ P.79 “Type 1 Printer: Loading
		Paper and Other Media”
		⇒ P.88 “Type 2 Printer: Loading
		Paper and Other Media”
Error	The toner cartridge may not	Open the front cover and check if
SC_320	be installed when the printer	the cartridge is installed. If not,
	tries to start printing.	install the cartridge. ⇒ P.114 “Re-
		placing the Toner Cartridge”
		If the cartridge is installed, close
		the front cover and turn the
		printer's power switch off and
		on. If the message appears again,
		contact your sales or service rep-
		resentative.
Error	An error has occurred in the	Remove the network interface
SC_2700	optional network interface	board from the printer and turn
	board.	the printer's main switch off and
Error
		on. Then, try to perform your
SC_3200		print job.

Error		Note
SC_3201		❒ If you remove the network in-
		terface board, you cannot per-
		form your print job over the
		network. You can send your
		print job to the printer only
		via a parallel cable connec-
		tion.
Error	An error has occurred in the	Remove the memory unit from
SC_3100	optional memory unit	the printer and turn the printer's
	(SIMM).	main switch off and on. Then, try
		to perform your print job.

Note

❒ If you remove the memory unit, you might not be able to perform a print job containing the large complex data.

10

103