Ricoh AP1400/AP2000 manual 102, Unit accidentally

10

Troubleshooting

Messages	Description	Comments
Memory Overflow	There is not enough memory	If the “Auto Continue” feature is
	to print the data.	set to on, press {Enter} to print
		out the data. To clear this mes-
		sage, change the print resolution
		from 1200dpi to 600dpi or 600dpi
		to 300dpi, and try printing again.
		If the print result is not enhanced,
		you should increase the memory
		capacity.
Print Overrun	The data sent to the printer	Press {Enter} to print out the data
	was too complex.	sent to the printer. If you don't
		want to lose any of the trans-
		ferred data, set the “Page Pro-
		tect” feature to “On”, before
		printing the job. If you can't clear
		this message, simplify the print
		job.
		Note
		❒ Make sure to return the “Page
		Protect” feature to “Off” after
		the print job. With the “Page
		Protect” feature “On”, the
		printer performance might be
		decreased.
Remove Misfeed	There is a misfeed in the	Remove the misfed paper.
Front Cover&Tray	printer.	⇒ P.110 “Removing Misfed Paper”
Remove Misfeed	There is a misfeed in the	Remove the misfed paper.
Open Front Cover	printer.	⇒ P.110 “Removing Misfed Paper”
Replace	The fusing unit is not set cor-	Set the fusing unit correctly.
Fusing unit	rectly.	⇒ P.113 “If you uninstall the fusing
		unit accidentally”
Replace	It is time to replace parts in-	Replace parts. For more informa-
Maintenance Kit	cluded in the Maintenance	tion on the Maintenance Kit, see
	Kit.	“Operating Instructions” that
		comes with the Kit.
Replace	The toner cartridge is not set	Set the toner cartridge correctly.
Toner Cartridge	correctly or toner is almost
		Prepare a new toner cartridge. If
	running out.
		the image density gets too light,
		replace the toner cartridge with a
		new one.
		⇒ P.114 “Replacing the Toner Car-
		tridge”

102