Replacing Parts

Printing the Test Page

You can confirm that the printer works properly by printing a test page (configuration page).

A Insert the plug of the power cord

2 securely into the wall socket. Turn the printer's power switch on.

B Load paper with the print side up into the paper tray. Slide the pa- per tray into the printer until it stops.

TS4M250E

Note

If you have an optional paper feed unit, repeat the above pro- cedure for the tray.

C Move the printer to the place where it was installed. If you have the optional paper feed unit, place the printer securely on the unit.

D Print the test page following the procedure below:

APress {Menu}.

The following message appears on the panel display.

B Press {U}{T} until the follow- ing message appears on the panel display.

Main Menu:

j

List Print

l

 

 

CPress {Enter}.

The following message appears on the panel display.

List Print: j 1.Config. Page l

DPress {Enter}.

The following message appears on the panel display.

Config. Page

Press Enter Key

EPress {Enter} .

In a short time, the test printing will start.

E If you can complete the test print- ing completely, turn off the print- er's power switch.

Note

If you cannot complete the test printing completely, confirm that all of the parts are installed correctly referring to the men- tioned procedures.

F Attach the interface cable to the interface connector of your print- er. Turn on the printer's power switch.

Main Menu: j Job Control l

12

Page 211
Image 211
Ricoh AP1400/AP2000 manual TS4M250E