Installing Options

F Attach the network interface ca- ble to the jack on the board as shown in the illustration.

2

TS3C041E

Important

The memory unit can be damaged by small amount of static electrici- ty. Before touching it, touch some- thing metal to remove static electricity from you.

To make the printer recognize the installed option, you should set up the option with the printer driver.

This printer has one slot for a SIMM, and you can install one SIMM at a time.

G Connect the other end of the net- work interface cable to the net- work.

H Plug the printer's power cord back into the wall outlet and turn on the printer's power switch.

The configuration page of the net- work interface board will be print- ed automatically. Check the configuration of the network inter- face board with it.

Important

After installing the network in- terface board properly, set up the printer's network environ- ment using the operation panel. See P.25 “Configuring the Printer for the Network with the Operation Panel”.

Type 1 Printer: Installing the Memory Unit (SIMM)

Note

Please refer to the inside of the front cover of this manual to con- firm which printer (Type 1 Printer or Type 2 Printer) you have.

A Be sure to check the following points:

The printer's power switch is turned off.

The power cord is unplugged from the wall outlet.

B Remove the back plate.

TS3P030E

Note

A coin can be used to remove the screws.

C Make sure that the notch of the memory unit should be upward as shown in the illustration. Tilt the memory unit to the left so that it is in 45 degrees from perpendic- ular to the slot, and slide it into the slot (A). Tilt the memory unit so that it is perpendicular to the

18

Page 38
Image 38
Ricoh AP1400/AP2000 manual Type 1 Printer Installing the Memory Unit Simm