Ricoh AP1400/AP2000 manual Type 2 Printer Installing Options

Installing Options

Type 2 Printer: Installing Options

Type 2 Printer: Installing the Paper Feed Unit Type 1400

2 Note

❒Please refer to the inside of the front cover of this manual to con- firm which printer (Type 1 Printer or Type 2 Printer) you have.

Important

❒Do not slide more than one paper tray out at a time. Having more than one paper tray filled with pa- per in a fully extended position could cause the machine to tilt for- ward.

❒To make the printer recognize the installed option, you should set up the option with the printer driver.

A Check the contents of the box for the following items.

•Paper feed unit (including a paper tray)

•Installation Guide

B Be sure to check the following points:

•The printer's power switch is turned off.

•The power cord is unplugged from the wall outlet.

•The interface cable is un- plugged from the printer.

•The bypass tray and front cov- er are closed.

C At the front of the paper feed unit, tape on the left and right sides is used to hold the tray in place. Re- move both pieces of tape.

D There are four pins on the top of the paper feed unit that point straight up. On the bottom of the printer are four holes. Align the holes over the pins and lower the printer gently onto the paper feed unit.

TS4P121E

RCAUTION:

•When lifting the printer, use the inset grips on both sides.

TS4K010E

E Pull the paper tray out until it stops. After then, lift it slightly,

20