Ricoh AP1400/AP2000 manual Cd-Rom

Type 1 Printer: Installing Options

❒Use the shielded twisted-pair (STP) network interface cable.

❒The network interface board can be attached to either the left or the right side of the back of your print- er. This procedure is for attaching to the left side.

❒You cannot install two network in- terface boards at a time.

A Check the contents of the box for the following items.

•Network interface board

•CD-ROM

•Ferrite Core

•Installation Guide

•Quick Configuration Guide

•Additional Documentation

B Be sure to check the following points:

•The printer's power switch is turned off.

•The power cord is unplugged from the wall outlet.

C Remove the back plate.

TS3P080E

Note

❒A coin can be used to remove the screws.

D Align the screw holes of the net- work interface board over the screw holes where the back plate

used to be. Make sure that the board is aligned so that the jack is facing out and is on the bottom. Press the board firmly against the printer. The interface connectors on the printer and the board should align and offer a slight re- sistance before popping into

place.2

TS3P090E

Note

❒Use a coin to reattach the screws.

E Loop the network interface cable and attach the ferrite core as shown in the illustration.

1

TS3P110E

Note

❒The network interface cable loop should be about 15 cm (6") (A) from the end of the cable (on the end closest to the print- er). The ferrite core at the end of the cable should be a ring type ferrite core.

17