Ricoh AP1400/AP2000 manual Making Connection and Main Menu, Configure IP Parameters

7.5.1Making Connection and Main Menu

1.At the prompt, type:

2.telnet <Network Interface Board IP address>

3.When login: appears, type guest if you are only interested in browsing the menus or sysadm if you want to change the configuration. Press the ENTER key.

4.When password: appears, again type guest or sysadm and press the ENTER key.

5.The main menu is displayed. This utility lets you change the IP Parameters, lpd/lpr printers, protocols, restore to factory defaults, and change password. Press the number for the parameter you wish to check or change and press the ENTER key.

The Configuration Utility

Unit Serial no. 991398 v2.18

Main Menu

1.IP Parameters

2.LPD Printers

3.Protocols

4.Reset Unit

5.Restore Factory Defaults

6.Change Password

7.Exit

Enter Selection (? for Help) :

To end your Telnet session, type E at the Main Menu. If you have made any changes you are prompted to either Save Changes and Exit or Exit Without Saving Changes. Choose your option and press the ENTER key.

Note: Press ? to access the Telnet help utility.

7.5.2Configure IP Parameters

Although the Network Interface Board must have an IP address before a Telnet Connection can be made, you can use the utility to change the address or the other IP parameters. The Network Interface Board will automatically initiate a soft reset when the IP address change is sensed.

Note: This will cause the Telnet connection to be broken. It is advisable to make all other desired changes before changing the IP address.

1.At the Main Menu, type 1 and press the ENTER key to bring up the IP Parameters menu (shown on the next page).

Chapter 7 - 17