Configuring the Parent Hub
If you plan to manage cascaded hubs with Fibre Channel Manager, configure the hub connected to the LAN as a parent hub.
1.From the Main menu, enter 2 (Set Networking parameters) to display the Network Setup menu.
Network Setup Menu:
1.Return to Main Menu
2.Select IP address [current = nnn.nnn.nnn.nnn]
3.Select Subnetworking Mask [current = nnn.nnn.nnn.nnn]
4.Select Default Gateway address [current = nnn.nnn.nnn.nnn]
5.Save Network Setup changes and reboot
6.Proxy Master Setup
2.Enter 6 to display the Proxy Master menu:
Proxy Master Menu: <Current state: Proxy Master ENABLED>
1.Return to previous Menu
2.Toggle current Proxy Master state and reboot
For the parent hub, verify that the master is ENABLED, then enter 1 to return to the Network Setup menu. Enter 1 again to return to the Main menu.
3.Enter 5 to save your changes. The hub is rebooted with the new values.
4.Close the terminal connection and disconnect the serial cable.
Configuring the Child Hub
If you plan to manage cascaded hubs with Fibre Channel Manager, configure the hub that is connected to the parent hub as a child hub.
1.Set up an
RS-232 Interface Functions
Enabling Hub Management | 61 |
