Figure 12 Hub Correctly Installed in a Rack

Installation

12.Plug the PDU cable into the cabinet PDU when you are ready to power on the hub. The hub finishes the self-test in less than 15 seconds. Verify that the hub passes the self-test.

If the Fault LED (amber) stays on after self-test, the hub failed. Refer to chapter 4, Troubleshooting, or contact an HP service representative for assistance.

If the Power LED is not lighted, refer to chapter 4, Troubleshooting, or contact an HP service representative.

13.Reinstall filler panels over the plenum shroud.

Procedure 4: Mount the Hub into a Rack (Optional)

31

Page 33
Image 33
HP Intrusion Prevention System S10, L10 manual Hub Correctly Installed in a Rack