Reinstalling the Hub Device Agent Code

1.From the Boot menu, enter 1 to update the device agent code. A prompt appears for you to begin file transfer; for example:

Ready to download Device Agent code to RAM Start ASCII file (S-record format) transfer now

<Refer to terminal emulator user manual for instructions> Press control-C at any time to cancel

2.From the terminal emulator application, use the transfer option to send a text file. The appropriate file was previously downloaded as a compressed file from the Hewlett- Packard Software Depot (http://www.software.hp.com).

For model S10 short-wave hubs, send the following file:

IFCH3719.FRM

For model L10 long-wave hubs, send the following file:

IFCH3720.FRM

The screen is filled with rows of progress indicator dots as the file is transferred; for example:

...................................................................

...................................................................

...................................................................

.....................................................

The transfer process can take 10 to 40 minutes.

When the file transfer has been completed, status messages and a transfer prompt appear; for example:

Done, memory range [$00001000:$0005B666]

Ready to transfer Device Agent code from RAM to FLASH

Note, once started, this step must not be interrupted

Press Enter to start, control-C to cancel

The values displayed for memory range represent low-level diagnostics. The values displayed in the status message can be different from the values shown here.

Troubleshooting

If Firmware Upgrade Appears to Fail

81

Page 83
Image 83
HP Intrusion Prevention System S10, L10 manual Reinstalling the Hub Device Agent Code, IFCH3720.FRM