Overview
This chapter describes how to use the
To configure the hub for Fibre Channel Manager or another management application, use the hub’s configuration menus to set SNMP values and the IP address.
If you do not plan to manage the hub with Fibre Channel Manager or another management application, you do not have to update the firmware or enable hub management. You do not have to update hub firmware to run diagnostic tests or view hub information.
Before beginning the procedures in this chapter, determine the configuration values that are required for the hub. Obtain IP addresses from the network administrator for the LAN to which the parent hub is connected. IP addresses are optional for the child hub. Values can be written in the spaces of the following worksheet.
Table 1 Worksheet for Hub Configuration
Parameter | Parent Hub | Child Hub (if any) |
|
|
|
Firmware version (hub controller) |
| Same as parent |
|
|
|
Firmware version (device agent) |
| Same as parent |
|
|
|
Proxy master option | ENABLED | DISABLED |
|
|
|
Port bypass persistence option | DISABLED | DISABLED |
|
|
|
Hub IP address |
|
|
Subnet mask |
|
|
Default gateway address |
|
|
Trap IP address (optional, max. of 4) |
|
|
Trap IP address (optional, max. of 4) |
|
|
Trap IP address (optional, max. of 4) |
|
|
Trap IP address (optional, max. of 4) |
|
|
|
|
|
42Overview