Ricoh AP1400/AP2000 manual Replacing the Friction Pad, Pull the tray out of the printer

Replacing the Friction Pad

Replacing the Friction Pad

Replace the friction pad of the stan- dard tray (tray 1). It is not necessary to replace the friction pad of the op- tional paper tray(s).

RCAUTION:

•The paper tray does not have a stopper. When pulling it out, be careful not to pull it strongly. If you do, the tray might fall and cause personal injury.

A Pull the tray out of the printer.

TS4M080E

B Remove paper from the paper tray. Turn the tray upside down and place it on a flat surface.

TS4M090E

C Release the two black catches, that lock the friction pad, using a

sharp-pointed item such as a ball- point pen.

2

TS4M101E

D Turn the paper tray to the original position, and remove the friction pad from the tray.

TS4M111E

E Insert the new friction pad in the paper tray. When inserting, note the following:

A The three triangular projec- tions should be facing toward the front side of the tray as shown in the illustration.

B Align the center projection of the new friction pad to the spring of the paper tray.

C Also, align the projections of both sides of the friction pad to

7