Marantz SR5001 Connections, 3.4, Height Of The Speaker Units, Connecting Speaker Wire, Subwoofer

CONNECTIONS

Surround left and right speakers

When the SR4001/SR5001 is used in surround operation, the preferred location for surround

CONNECTING SPEAKERS

SPEAKER PLACEMENT

The ideal surround speaker system for this unit is 7- speaker systems, using front left and right speakers, a center speaker, surround left and right speakers, a surround back left and right speakers, and a subwoofer.

speakers is on the side walls of the room, at or slightly behind the listening position.

The center of the speaker should face into the room.

Surround back left and right speakers

Surround back speakers are required when a full 7.1- channel system is installed.

Passive	Power
subwoofer	Amplifier
INVERT	INPUT INPUT	BTL EXT. CONT. IN	REMOTE CONT.
OUTPUT	LEVEL
		VIDEO/	SYSTEM OUT OUT	IN
		+5~13V DC
	SPEAKER SYSTEM
	MINIMUM 4 OHMS

Surround

PoweredBACK subwoofer

Right Left

or

ENGLISH

For best results we recommend that all front speakers be of the same type, with identical or similar driver units. This will deliver smooth pans across the front sound stage as the action moves from side to side.

Your center channel speaker is very important as over 80% of the dialog from a typical motion picture emanates from the center channel.

It should possess similar sonic characteristics to the

Speakers should be placed on a rear wall, behind the listening position.

The center of the speaker should face into the room.

Subwoofer

We recommend using a sub-woofer to have maximum bass effect. Sub-woofer bears only low frequency range so you can place it any where in the room.

	INPUT		COMPONENT
VIDEO	1	INPUT		HDMI Ver 1.1
			VIDEO
		3

FM (75Ω)

S-VIDEO

MONITOR

GND

AM

OUT 2

ANTENNA

INPUT

INPUT 1

INPUT 2

OUTPUT

TV

DVD

VCR IN

VCR OUT DSS/VCR2 MONITOR OUT

2

Y

CB/PB

CR/PR

Y

CB/PB

CR/PR

Y

CB/PB

CR/PR

L

SL

C

SBL

3

4

COAX

IN

L

R

R

SR

SW

SBR MULTI.

IN

OUT

IN

IN

OUT

IN

OUT

1

2

3

OPT

OUT

FLASHER

DC

(AUX2)

7.1CH INPUT

OUT

TV

DVD

VCR1

DSS/VCR2 CD

TAPE

CDR/MD

DIGITAL IN

DIGITAL OUT

RC-5

IN

TRIGER

main speakers. Surround channel speakers need not be identical to the front channel speakers, but they should be of high quality.

The surround back speaker is useful for playback of Dolby Digital Surround EX or DTS-ES. One of the benefits of both Dolby Digital and DTS is that surround channels are discrete full range, while they were frequency limited in earlier “Pro Logic’ type systems.

HEIGHT OF THE SPEAKER UNITS

Front left and right speakers, and a center speaker Align the tweeters and mid-range drivers on the three front speakers at the same height, as best as possible.

Surround left and right speakers, and surround

	RS-232C	SPEAKER C
		OFF ON
L	SL	C	SBL

RSR SW SBR

PRE OUT

R	L	R	L
	FRONT B		FRONT A

FRONT A OR B.CENTER. SURR.SURR BACK : 6-8 OHMS FRONT A + B : 8 OHMS

AUDIO
R	L	R	L
					MODEL NO. SR5001
					AC IN
SURROUND BACK		SURROUND		CENTER	AC OUTLET
SPEAKER C/				SPEAKER	230V 50/60Hz
MULTI SPEAKER				SYSTEMS	SWITCHED
					0.65A 150W

Bass effects are an important part of home theater. For optimal enjoyment a subwoofer should be used as it is optimized for low frequency reproduction. If you have full range front speakers, however, they may be used in place of a subwoofer with proper setting of the switches in the menu system.

Subwoofer

Surround Left

Front Left

Surround Back

Left

back speaker

Place the surround left, right and surround back speakers higher than your ears by about 70cm – 1m. Also place the speakers at the same height, as best as possible.

70cm

1m

Center

Right	Left	Right	Left	Right	Left
		Front A		Surround
Front B

SR5001 only

		Front Center
		0°
Surround Back		22°
Right
150°		30°
135°	Surround Right	Front Right
110°
	90°

Front left and right speakers

We recommend to set the front L and R speakers with 45-60 degrees from the listening position.

Center speaker

Align the front line of the center speaker with the front L/R speakers. Or place the center speaker a little backward from the line.

Note:

Use magnetically-shielded speakers for front left, right and the center speakers when the speakers are installed near the TV and the TV is a monitor type.

CONNECTING SPEAKER WIRE

1. Strip away approx. 3/8 inch (10 mm) of wire insulation.

2. Twist the bared wire ends tight, to prevent short circuits.

3. Loosen the knob by turning it counterclockwise.

4. Insert the bare part of the wire into the hole in side of each terminal.

5. Tighten the knob by turning it clockwise to secure the wire.

1.2.

10mm

3.4. 5.

17