730CHAPTER 51: CONFIGURING DCC

Configuring the timeout of call setting up

When placing DCC calls to some remote ends, the intervals between originating the calls and establishing the connections are not the same. To effectively control the time that should wait for the connection after a call is originated, the user can configure the wait-carrier timer to specify a duration, after which DCC will terminate the call if the connection cannot be established.

Perform the following configuration in dial interface (physical or dialer interface) view.

Table 771 Configure the Timeout of Call Setting Up

Operation

Command

 

 

Configure the timeout of call setting up

dialer timer wait-carrier seconds

 

 

Restore the timeout of call setting up to

undo dialer wait-carrier

the default value

 

 

 

By default, the timeout of call setting up is 60 seconds.

Configuring the buffer queue length of the dialer

Before a dialer buffer queue is established, a packet received from the dial interface will be discarded if the connection is not established yet. However, if a buffer queue is established on the dial interface, the packet will be held until a connection is established rather than discarded.

Perform the following configuration in dial interface (physical or dialer interface) view.

Table 772 Configure the Buffer Queue Length of the Dial Interface

Operation

Command

 

 

Configure the buffer queue length of the

dialer queue-length packets

dial interface

 

 

 

Remove the buffer queue length of the

undo dialer queue-length

dial interface

 

 

 

By default, no buffer queues are configured on dial interfaces.

Displaying and

After completing the above configuration steps, execute the display command in

Debugging DCC

all views to display the running of the DCC configuration, and to verify the effect

 

of the configuration.

 

 

Execute debugging command in all views for the debugging.

 

Table 773 Display and Debug DCC

 

 

 

 

 

Operation

Command

 

 

 

 

Display the dial interface information

display dialer interface [

 

 

interface-type interface-number ]

 

 

 

 

Display the statically configured or

display dialer route [ detail ]

 

dynamically formed dial number route.

 

 

 

 

 

Enable DCC debugging

debugging dialer { event packet }

Page 734
Image 734
3Com 10014299 Debugging DCC, Configuring the timeout of call setting up, Configuring the buffer queue length of the dialer