3Com 10014299 manual Router-Serial215ppp authentication-mode chap

744CHAPTER 51: CONFIGURING DCC

cStart dialing, and input the user name user1 and the password pass1.

Solution 2:

The dialing side uses a single number to dial, and the accessing side uses circular DCC to set up the connection via the ISDN PRI interface. Configure the DCC parameters on the dialer interface.

1Configure RouterC:

[Router] dialer-rule 1 ip permit

[Router] local-user userb password simple passb

[Router] interface bri 0 [Router-Bri0] ip address ppp-negotiate

[Router-Bri0]dialer-group 1[Quidway-Bri0] dialer enable-circular

[Router-Bri0]dialer route ip 100.1.1.254 8810148

[Router-Bri0]link-protocol ppp

[Router-Bri0]ppp chap user user1

[Router-Bri0]ppp chap password simple pass1

2Configure RouterD:

[Router] dialer-rule 2 ip permit

[Router] local-user user1 password simple pass1

[Router] local-user user2 password simple pass2

……

[Router] local-user user16 password simple pass6

[Router] ip pool 1 100.1.1.1 100.1.1.16

[Router] controller e1 2 [Router-E1-2]pri-set

[Router-E1-2] interface serial 2:15 [Router-Serial2:15] ip address 100.1.1.254 255.255.255.0

[Router-Serial2:15]remote address pool 1

[Router-Serial2:15]dialer enable-circular

[Router-Serial2:15] dialer-group 2

[Router-Serial2:15] link-protocol ppp

[Router-Serial2:15]ppp authentication-mode chap

[Router-Serial2:15] ppp chap user userb

[Router-Serial2:15]ppp chap password simple passb

Logical Interface RouterA and RouterB are directly connected via the serial interfaces. At the same Standby through Dialer time, RouterA forms a dialup connection with RouterB via a modem through

route for DCC PSTN. RouterB cannot call RouterA via dialing.

As shown in Figure 240, a logical interface is generated through configuring the dialer route command on RouterA. This interface can be used as either the standby interface for other interfaces or the main interface. The port Serial0 on RouterA is used as the dialer interface, and Serial1 is connected to RouterB through straightforward DDN. The address of Serial0 on RouterA is 100.1.1.1, and the address of the Serial1 connected to DDN is 200.1.1.1. The address of the dialer interface on RouterB is 100.1.1.2, and the address of the interface connected to DDN is 200.1.1.2.