IPV6 UNICAST POLICY ROUTING

69 CONFIGURATION COMMANDS

apply default output-interface

Syntax apply default output-interface interface-typeinterface-number

undo apply default output-interface [ interface-typeinterface-number]

View IPv6 policy-based-route view

Parameter interface-type interface-number: Specifies an interface.

Description Use the apply default output-interfacecommand to set a default outgoing interface for IPv6 packets.

Use the undo apply default output-interface command to remove the default outgoing interface.

This command only applies to packets not finding a match in the routing table. You can specify up to five default outgoing interfaces, implementing load balancing based on data streams.

Related command: apply ipv6-precedence,apply ipv6-addressnext-hop,apply output-interface,apply ipv6-address default next-hop.

Example # Set the default outgoing interface to the interface Serial 2/0.

<Sysname> system-view

[Sysname] ipv6 policy-based-route aa permit node 11

[Sysname-pbr6-aa-11] apply default output-interface serial 2/0

apply destination-based-forwarding

Syntax apply destination-based-forwarding

undo apply destination-based-forwarding

View IPv6 policy-based-route view

Parameter None

Page 889
Image 889
3Com MSR 50, MSR 30 manual IPV6 Unicast Policy Routing Configuration Commands, Apply destination-based-forwarding