3Com MSR 50, MSR 30 manual Related command Reset pppoe-client, Related command pppoe-client

541

	Ethernet interface, this dialer bundle can also not be added to the Ethernet
	interface used by PPPoE Client.
	When PPPoE session works in permanent online mode, and the physical lines go
	UP, the device will immediately initiate PPPoE call to establish PPPoE session. This
	PPPoE connection will exist constantly unless users use the command undo
	pppoe-clientto delete PPPoE session. When PPPoE session works in packet
	trigger mode, the device will not initiate PPPoE call to establish PPPoE session
	unless it has data to transmit. If there is no data transmission on the PPPoE link
	within seconds, the device will automatically terminate PPPoE session. Only after it
	has new data to transmit, PPPoE session will be re-established.
Related command:	reset pppoe-client.
	The difference between the reset pppoe-clientcommand and the undo
n pppoe-client command lies in: the former only temporarily terminates a PPPoE
	session, while the latter permanently deletes a PPPoE session.
	No matter a PPPoE session works in permanent on-line mode or in packet
	triggering mode, it will be deleted permanently by the undo pppoe-client
	command. If it is necessary to recreate a PPPoE session, the user must reconfigure
	it.
Example	# Create a PPPoE session on the interface Ethernet 1/0.
	<Sysname> system-view
	[Sysname] interface ethernet 1/0
	[Sysname-Ethernet1/0] pppoe-client dial-bundle-number 1
reset pppoe-client
Syntax	reset pppoe-client { all dial-bundle-number number }
View	User view
Parameter	all: Clears all PPPoE sessions.
	dial-bundle-numbernumber: Dialer bundle number, in the range 1 to 255,
	which is used to clear the PPPoE session corresponding to dialer bundle.
Description	Use the reset pppoe-clientcommand to terminate PPPoE session and re-initiate
	the connection later.

When a PPPoE session works in permanent on-line mode, if it is terminated by the reset pppoe-clientcommand, the device will automatically recreate a PPPoE session in 16 seconds. When a PPPoE session works in packet triggering mode, if it is terminated via the reset pppoe-clientcommand, the device will recreate a PPPoE session only upon data transmission.

Related command: pppoe-client.