Robic SC-587 Minutesecond, Preset Time Additional Total Time, HOW to USE Chronograph

-Each press of S1 will select the digits to be adjusted. They will appear flashing. Press and hold S1 for rapid digit advance.

-With each press of S3, the next digits for setting can be selected. The sequence is as follows:

S3

S3

MINUTESECOND

-After all adjustments are completed, press S4 to exit the setting mode.

-Press S1 to start or stop the timer.

-When the timer counts down to zero, additional time will count up automatically. “TOTAL” time (Countdown Time

+Additional Time) is displayed, when additional time is stopped by pressing S1.

PRESET TIME	S1
ADDITIONAL
TIME	TOTAL TIME

- When the timer is stopped, press S2 to reload the last preset time. Continue to press S2 to select the

3pre-determined countdown times including 10 minutes, 15 minutes and 45 minutes. Notes:

1.The Sport CountdownTimer has 1-second resolution. The working range is from 1 second to 99 minutes 59 seconds for both the countdown time and the additional time.

2.If the “TOTAL” time exceeds 99 minutes 59 seconds, the watch will display as follows:

S1

TOTAL TIME: 162 minutes 55 seconds

3.The SC-587 will sound 3 beeps at 3 minutes, 2 beeps at 2 minutes and 1 beep at 1 minute before the timer counts down to zero. Then it will beep for 5 seconds when the timer counts down to zero. Press any button (except S5) to silence the sound.

4.When additional time is counting, an arrow pointing upwards is displayed.

5.If there is no button operation for 2-3 minutes in setting mode, the watch will return back to Sport Timer mode automatically.

(H) HOW TO USE CHRONOGRAPH

S4S1

S3S2

S5

-Press S3 to display the Chronograph mode. “Chron” will be displayed for 1 second.

-Press S1 to start the chronograph. “Run” will appear.

-For the first hour, the chronograph shows minutes, seconds and 1/100-seconds. Then the chronograph shows hours, minutes and seconds.

-Press S2 to take a split and lap time. The split time and “SPL” will be displayed for 6 seconds, then the lap time and “LAP” will be displayed for 6 seconds. Then the display will return to the current running time. Press 4

for fast escape.

-Press S2 again to take the next split and lap time.

-Press S1 to stop the chronograph. “STP” will be displayed. Then press S1 again to re-start the chronograph, or press S2 to reset the chronograph back to all zeros.

Remark:
The chronograph has 1/100-second resolution for the first hour and 1-second resolution after that,
up to 99 hours 59 minutes 59.99 seconds, at which time the chronograph will stop automatically.
The enclosed design is proprietary intellectual property owned by
National Electronics & Watch Co., Ltd. and it may NOT be used,
copied or distributed except with authorization in writing from	4
National Electronics & Watch Co., Ltd.