3Com MSR 30, MSR 50 Undo rip triggered, Rip version 1 2 broadcast multicast, Undo rip version

1180 CHAPTER 77: RIP CONFIGURATION COMMANDS

undo rip triggered

View Interface view

Parameters None

Description Use the rip triggered command to enable triggered RIP.

Use the undo rip triggered command to disable triggered RIP.

By default, the triggered RIP is disabled.

Note that triggered RIP can only run on link layer protocols PPP, Frame Relay, and

X.25.

Examples # Enable triggered RIP.

<Sysname> system-view

[Sysname] interface serial 2/0

[Sysname-Serial2/0] rip triggered

rip version

Syntax	rip version { 1 2 [ broadcast multicast ] }
	undo rip version
View	Interface view
Parameters	1: RIP version 1.
	2: RIP version 2.
	broadcast: Sends RIP-2 messages in broadcast mode.
	multicast: Sends RIP-2 messages in multicast mode.
Description	Use the rip version command to specify a RIP version for the interface.
	Use the undo rip version command to remove the specified RIP version.
	By default, no RIP version is configured for an interface, which uses the global RIP
	version. If the global RIP version is not configured, the interface can only send
	RIP-1 broadcasts and can receive RIP-1 broadcasts and unicasts, and RIP-2
	broadcasts, multicasts and unicasts.
	If RIP-2 is specified with no sending mode configured, RIP-2 messages will be sent
	in multicast mode.
	When RIP-1 runs on an interface, the interface will: