1615

Example # Enable RSVP message retransmission on interface Ethernet 1/0, setting the increment value delta to 2 and the initial retransmission interval to 1000 milliseconds.

<Sysname> system-view

[Sysname] interface ethernet 1/0

[Sysname-Ethernet1/0] mpls rsvp-te timer retransmission increment-va lue 2 retransmit-value 1000

mpls te

Syntax mpls te

undo mpls te

View MPLS view, interface view

Parameter None

Description Use the mpls te command to enable MPLS TE.

Use the undo mpls te command to disable MPLS TE.

By default, MPLS TE is disabled.

When performed in MPLS view, the mpls te command enables MPLS TE globally and its undo form disables MPLS TE and removes all CR-LSPs.

When performed in interface view, the mpls te command enables MPLS TE on an interface and its undo form disables MPLS TE and removes all CR-LSPs on the interface.

Before you can enable MPLS TE on an interface, enable MPLS TE globally first.

c CAUTION: After changing the MTU of an interface where MPLS TE is enabled, you need to perform the shutdown command and then the undo shutdown command to refresh the TE tunnels on it.

Example # Enable MPLS TE globally in MPLS view.

<Sysname> system-view [Sysname] mpls lsr-id 1.1.1.9

[Sysname] mpls [Sysname-mpls] mpls te

# Enable MPLS TE on interface Ethernet 1/0.

<Sysname> system-view

[Sysname] interface ethernet 1/0

[Sysname-Ethernet1/0] mpls

[Sysname-Ethernet1/0] mpls te

Page 1615
Image 1615
3Com MSR 50, MSR 30 manual Mpls te, Syntax mpls te, Undo mpls te, # Enable Mpls TE on interface Ethernet 1/0, 1615