GarrettCom Magnum ST80 manual Using the Stack Enable switch

Stackable Personal Hubs Installation and User Guide (04/01)

4.4Using the Stack Enable switch

The Stack Enable switch of the ST80 is used to configure each unit of the stack. If an ST80 is being used as a non-stacked unit, the Stack Enable switch must be in the “OFF” position. When two or more ST80s are stacked, the bottom unit should be set to the “OFF” position, and all other units should be in the “ON” position. For further information about the Stack Enable switch, see Section 3.9, “Stacking the ST80s”.

www . GarrettCom . com

21