3Com MSR 50 manual Related command frame-format, Example # In SDH mode, multiplex AUG to AU-3, 683

683

au-4: Gets AUG through AU-4.

Description Use the multiplex mode command to set AUG multiplexing mode.

Use the undo multiplex mode command to restore the default, that is, au-4.

SDH provides two payload mapping/multiplexing solutions: ANSI and ETSI.

■ANSI uses the AU-3 multiplexing scheme, where the lower-order payload is aggregated into the VC-3 higher-order path. VC-3 plus an AU pointer forms AU-3. Three such AU-3s can be synchronized and multiplexed to form one AUG.

■ETSI uses the AU-4 multiplexing scheme, where the lower-order payload is aggregated into the VC-4 higher-order path. VC-4 plus an AU pointer forms an AU-4. This AU-4 can be synchronized and multiplexed to form one AUG.

When the CPOS interface is operating in SDH mode, you can choose to multiplex AUG to AU-4 or AU-3 by using the multiplex mode command. When the CPOS interface is operating in SONET mode, AUG can be multiplexed only to AU-3 and the multiplex mode command is invalid in this case.

Related command: frame-format.

Example # In SDH mode, multiplex AUG to AU-3.

<Sysname> system-view [Sysname] controller cpos 1/0 [Sysname-Cpos1/0] frame-format sdh

[Sysname-Cpos1/0] multiplex mode au-

shutdown

Syntax shutdown

undo shutdown

View CPOS interface view

Parameter None

Description Use the shutdown command to shut down the CPOS physical interface.

Use the undo shutdown command to bring up the CPOS physical interface.

By default, the CPOS physical interface is up.

The shutdown command on the CPOS physical interface shuts down all E1/T1 channels and serial interfaces formed by timeslot bundles. They stop transmitting and receiving data as a result. To bring up them, perform the undo shutdown command on the CPOS physical interface.