3Com MSR 50 manual StubOSPFv3 area view, Vlink-peerOSPFv3 area view, Related commands default cost

1307

stub(OSPFv3 area view)

Syntax stub [ no-summary ]

undo stub

View OSPFv3 area view

Parameters no-summary: This argument is only applicable to the ABR of a stub area. With it configured, the ABR advertises only a default route in a Summary-LSA to the stub area (such an area is called a totally stub area).

Description Use the stub command to configure an area as a stub area.

Use the undo stub command to remove the configuration.

By default, an area is not configured as a stub area.

When an area is configured as a stub area, all the routers attached to the area must be configured with the stub command.

Related commands: default cost.

Examples # Configure OSPFv3 area 1 as a stub area.

<Sysname> system-view [Sysname] ospfv3 1 [Sysname-ospfv3-1] area 1 [Sysname-ospfv3-1-area-0.0.0.1] stub

vlink-peer(OSPFv3 area view)

Syntax vlink-peerrouter-id [ hello seconds retransmit seconds trans-delayseconds dead seconds instance instance-id ] *

undo vlink-peer router-id[ hello retransmit trans-delay dead ]*

View OSPFv3 area view

Parameters router-id: Router ID for a virtual link neighbor.

hello seconds: Specifies the interval in seconds of sending Hello packets, ranging from 1 to 8192, with the default as 10. This value must equal to the hello seconds configured on the virtual link peer router.

retransmit seconds: Specifies the interval in seconds of retransmitting LSA packets, ranging from 1 to 3600, with the default as 5.

trans-delayseconds: Specifies the delay interval in seconds of sending LSA packets, ranging from 1 to 3600, with the default as 1.