3Com MSR 30, MSR 50 manual Ip count outbound-packets, Ip count rule

778CHAPTER 58: IP ACCOUNTING CONFIGURATION COMMANDS

ip count outbound-packets

Syntax ip count outbound-packets

undo ip count outbound-packets

View Interface view

Parameter None

Description Use the ip count outbound-packetscommand to count outgoing IP packets on the current interface.

Use the undo ip count outbound-packetscommand to restore the default.

By default, outgoing IP packets on the interface are not counted.

You can execute this command in interface view to count outgoing IP packets, which will be stored in the exterior table or interior table, depending on whether they match the accounting rules.

Example # Count outgoing IP packets on Ethernet1/0.

<Sysname> system-view

[Sysname] interface ethernet 1/0

[Sysname-Ethernet1/0] ip count outbound-packets

ip count rule

Syntax ip count rule ip-address { mask mask-length }

undo ip count rule {ip-address { mask mask-length } ]

View System view

Parameter ip-address: IP address.

mask: Subnet mask.

mask-length: Length of a subnet mask, in the range of 0 to 32.

Description Use the ip count rule command to create an IP accounting rule.

Use the undo ip count rule command to remove the specified accounting rule.

All IP accounting rules will be deleted if no parameter is specified.

Each IP accounting rule consists of an IP address and its mask, namely, a network address, which is the result of ANDing the IP address with its mask. IP packets are sorted as follows: