3Com MSR 50 manual E1 and T1 Configuration Commands, Ani all ka, Undo ani, Cas and ani-offset

E1 AND T1 CONFIGURATION

175 COMMANDS

ani

Syntax	ani { all ka }
	undo ani
View	R2 CAS view
Parameter	all: Specifies the remote end to send the category of the calling party and calling
	number.
	ka: Specifies the remote end to send only the category of the calling party.
Description	Use the ani command to enable the terminating point to request calling party
	information (service category and calling number) from the originating point
	during call connection.
	Use the undo ani command to disable the terminating point from requesting
	calling party information from the originating point.
	By default, the terminating point does not request calling party information from
	the originating point during call connection.
n	■ Configure the local end with this command to support automatic number
	identification.
	■ This command applies to R2 signaling only.
	■ Normally the all keyword is configured. Use the ka keyword only when
	required by the connected switch to prevent call failures.
Related command:	cas and ani-offset.
Example	# Request the remote office to send calling number category and calling number
	during call connection.
	<Sysname> system-view
	[Sysname] controller e1 1/0
	[Sysname-e1 1/0] timeslot-set 0 timeslot-list 1-31 signal r2
	[Sysname-e1 1/0] cas 0
	[Sysname-cas1/0:0] ani all