3Com MSR 50 Ospfv3 timer retransmit, Ospfv3 trans-delay, Related commands ospfv3 timer dead, 1303

1303

Related commands: ospfv3 timer dead.

Examples # Configure the hello interval as 20 seconds for an interface of instance 1.

<Sysname> system-view

[Sysname] interface serial 2/0

[Sysname-Serial2/0] ospfv3 timer hello 20 instance 1

ospfv3 timer retransmit

Syntax ospfv3 timer retransmit interval [ instance instance-id]

undo ospfv3 timer retransmit [ instance instance-id]

View Interface view

Parameters interval: Specifies LSA retransmission interval in seconds for an interface, ranging from 1 to 65535.

instance-id: The instance ID of an interface, in the range of 0 to 255, which defaults to 0.

Description Use the ospfv3 timer retransmit command to configure the LSA retransmission interval for an interface of an instance.

Use the undo ospfv3 timer retransmit command to restore the default.

The interval defaults to 5 seconds.

When a router sends a LSA to its neighbor, it waits for an acknowledgement. If receiving no acknowledgement after retransmission interval elapses, it will retransmit the LSA.

The LSA retransmission interval should not be too small for avoidance of unnecessary retransmissions.

Examples # Configure the LSA retransmission interval on an interface of instance 1 as 12 seconds.

<Sysname> system-view

[Sysname] interface ethernet 1/0

[Sysname-Ethernet1/0] ospfv3 timer retransmit 12 instance 1

ospfv3 trans-delay

Syntax ospfv3 trans-delay seconds [ instance instance-id]

undo ospfv3 trans-delay [ instance instance-id]

View Interface view