HOW TO USE THE INSTRUMENT

4 - 51

MEASURE

MEAS 2-FREQ

-Press the ’RETURN’ softkey to return to the ’MEASURE’ menu.

-Turn on MEAS 2.

MEAS 2 performs a frequency measurement on the same signal. The screen displays this result as : ’ch1 freq= ....kHz’.

-Remove the Probe Adjust signal from channel 1

Because of the absence of an input signal, no frequency can be measured. This results in the display ’ch1 freq= ----Hz’.

MEASURE

DELAY

-Connect the Probe Adjust signal to channels 1 and 2.

-Turn on channel 2.

-Shift the signal on channel 1 to the upper half of the screen and the signal on channel 2 to the lower half of the screen.

-Press the softkey next to MEAS1.

The SELECT MEAS1 submenu is displayed.

-Press the first softkey to select ’delay’

The delay measurement is performed automatically. Observe that the first measurement is linked to the channel 1 signal (on positive slope) and the second is listed to the channel 2 signal (on negative slope).

The delay is displayed in the top corner of the screen

’ch1: del = .... μs’.

1

2

DELAY

SELECT

 

MEAS 1

 

volt

 

time

 

delay

 

-

 

ch1

T

ch2

 

ch1

Δ

ch2

-

 

RETURN

ST6723

9303

-Press the RETURN softkey to return to the MEASURE menu.

This measurement is very useful when you must compensate unequal cable delays.

Page 96
Image 96
Fluke PM3370B user manual Measure Meas 2-FREQ, Measure Delay, Remove the Probe Adjust signal from channel