5 - 66

FUNCTION REFERENCE

REGISTER EMPTY

Recalling traces from an empty register is

 

not possible. Protection of an empty

 

register is impossible.

 

Function ’RECALL’.

REGISTER PROTECTED

Register cannot be saved in protected

 

memory location.

 

Function ’SAVE’.

REGISTER USED FOR MATH

Trace cannot be saved in register M1 or

 

M2, because it is in use for a MATH

 

function.

 

Function ’MATHEMATICS’.

SETUP EMPTY

Recalling settings from an empty memory

 

location is not possible. Protection of an

 

empty front is impossible.

 

Function ’SETUPS’.

SETUP PROTECTED

Settings cannot be saved in protected

 

memory location.

 

Function ’SETUPS’.

STD SETUP = RECALL ONLY

Save settings in the ’std’ front is not

 

possible.

 

Function ’SETUPS’.

TIME/DIV ADJUSTED

Set timebase to fastest Roll mode

 

position.

FOR ROLL

Function ’TB MODE’.

TOO MANY TRACES

Maximum allowed traces is eight.

SETUPS

Description:

Ten complete front panel settings can be saved into a battery backed-up memory. This feature is useful for routine measurements. Setups are stored in memory location labeled s1 .... s10. These memories are accessible under the menu key

SETUPS. The menu structure is shown in Appendix H.

Selection of the memories s1 ... s10 is done with the TRACK control. Memory location ’std’ is a factory-stored set of standard settings that can be used to put the instrument in a defined state. For a detailed specification, refer to the STANDARD FRONT function.

Page 186
Image 186
Fluke PM3370B Register Empty, Register Protected, Register Used for Math, Setup Empty, Setup Protected, TIME/DIV Adjusted