Fluke PM3370B user manual Program Communication, 16THE CPL Protocol, Xonxoff, Hwl

6 - 16THE CPL PROTOCOL

PROGRAM COMMUNICATION PC

Purpose:

To program baudrate, parity mode, number of data and stopbits and the handshake method for computer communication.

After the command is sent, an <acknowledge> will be returned with the old communication parameters still active.

If the <acknowledge> = 0, the new communication parameters will be valid approximately 0.5 seconds later. The communication parameters are stored in battery backup memory and restored on power-up.

This command performs the same function as the UTILITY + RS232 SETUP menu.

Command:

"PC"	pds	baud	pds	parity	pds	data bits
			to bypass handshake
pds	stop bits		pds	handshake		CR

<baud>	= 75, 110, 150, 300, 600, 1200, 2400, 4800, 9600, 19200,
		38400
<parity>	= O, E or N
<data bits>	=	7 or 8
<stopbits>	=	1
<handshake>	=	XONXOFF	to enable Xon/Xoff handshake
		HWL	to enable hardwareline handshake
		If left out, both handshake methods are disabled.