1626 CHAPTER 96: MPLS TE CONFIGURATION COMMANDS

View Tunnel interface view

Parameter None

Description Use the mpls te loop-detectioncommand to configure the node to perform loop detection when setting up the MPLS TE tunnel.

Use the undo mpls te loop-detectioncommand to disable loop detection.

Loop detection is disabled by default.

Example # Configure the node to perform loop detection when setting up tunnel 0.

<Sysname> system-view

[Sysname] interface tunnel 0

[Sysname-Tunnel0] mpls te loop-detection

mpls te max-link-bandwidth

Syntax mpls te max-link-bandwidth bandwidth-value[ bc1 bc1-bandwidth]

undo mpls te max-link-bandwidth

View Interface view

Parameter bandwidth-value: Maximum link bandwidth available for RSVP traffic, in the range 1 to 32000000 kbps.

bc1 bc1-bandwidth: Reservable bandwidth in kbps on the interface, in the range 1 to bandwidth-value.

Description Use the mpls te max-link-bandwidth bandwidth-value command to configure maximum link bandwidth.

Use the undo mpls te max-link-bandwidth command to remove the configuration.

The configured maximum bandwidth is available for both MPLS traffic and common best-effort traffic.

Example # On interface Serial 1/0 set maximum link bandwidth available for RSVP traffic to 1158 kbps, and the reservable bandwidth to 200 kbps.

<Sysname> system-view

[Sysname] interface serial 1/0

[Sysname-Serial1/0] mpls te max-link-bandwidth 1158 bc1 200

mpls te max-reservable-bandwidth

Syntax mpls te max-reservable-bandwidth bandwidth-value[ bc1 bc1-bandwidth]

Page 1626
Image 1626
3Com MSR 30, MSR 50 manual Mpls te max-link-bandwidth, Mpls te max-reservable-bandwidth