3Com MSR 30, MSR 50 manual Bridge bridging, Bridge enable, Example # Enable bridge set

550CHAPTER 36: BRIDGING CONFIGURATION COMMANDS

Example # Enable bridge set 1.

<Sysname> system-view

[Sysname] bridge 1 enable

bridge bridging

Syntax bridge bridge-setbridging { ip ipx others }

undo bridge bridge-setbridging { ip ipx others }

View System view

Parameters bridge-set: Bridge set number, an integer in the range of 1 to 255.

ip: Specifies the Internet protocol (IP).

ipx: Specifies the internetwork packet exchange (IPX) protocol.

others: Specifies other protocols than IP and IPX.

Description Use the bridge bridging command to enable bridging of the specified network layer protocol(s) on the specified bridge set.

Use the undo bridge bridging command to disable bridging of the specified network layer protocol(s) on the specified bridge set.

By default, bridging of all network layer protocols is enabled.

Note that non-routable packets will be discarded if bridging of IP or IPX is disabled in a bridge set.

Example # Disable IP bridging on bridge set 1.

<Sysname> system-view

[Sysname] undo bridge 1 bridging ip

# Enable IP bridging on bridge set 1.

<Sysname> system-view

[Sysname] bridge 1 bridging ip

bridge enable

Syntax bridge enable

undo bridge enable

View System view

Parameters None