3Com MSR 30, MSR 50 manual Display bridge traffic

556CHAPTER 36: BRIDGING CONFIGURATION COMMANDS

Table 91 Description on the fields of the display bridge information command

Field	Description
configure	Configuration properties of this bridge set. For example, the
	“configuration” part of bridge set 1 indicates that bridge set 1 can
	bridge IP packets, it cannot bridge IPX packets, and it can
	dynamically learn MAC addresses
interface	Interfaces in this bridge sets and their status, where up represents
	that the interface is active, while “down” represents that the
	interface is inactive. Bridging is possible only between active
	interfaces in the same bridge set.

n As shown above, bridge set 1 and bridge set 2 in the system are active. The information of each bridge set includes two parts: configure and interface.

display bridge traffic

Syntax display bridge traffic [ bridge-setbridge-set dlsw interface interface-type interface-number ]

View Any view

Parameters bridge-set: Displays the statistics information about bridged traffic in the specified

bridge set. bridge-setmust be an integer in the range of 1 to 255.

dlsw: Displays the statistics information of bridged traffic that has passed the DLSw module.

interface-typeinterface-number: Displays the statistics information about bridged traffic that has passed the specified interface.

Description Use the display bridge traffic command to view the statistic information about bridged traffic.

If no parameter is provided, this command displays the statistics about all the bridged traffic on the device.

Example # View the statistics information about bridged traffic that has passed

Ethernet1/0.

<Sysname> display bridge traffic interface ethernet 1/0 the statistic of interface Ethernet1/0 in bridge set 1 : Input:

10 total, 1 bpdu, 2 single,

0 multi, 0 broadcast;

0 ip,0 ipx, 0 other protocol;

0 eth2, 0 snap,

0 dlsw, 0 other,

0 vlan;

Output:

0 total, 0 bpdu, 0 single,

0 multi, 0 broadcast;

0 ip, 0 ipx, 0 other protocol;