3Com MSR 30 Super password, Related command super password, Undo super password level user-level

2422 CHAPTER 162: BASIC CONFIGURATION COMMANDS

■ System: provides service configuration commands, including routing and commands at each level of the network for providing services.

■ Manage: influences the basic operation of the system and the system support modules for service support. Commands at this level involve file system, FTP, TFTP, XMODEM download and configuration file switch, power control, standby board control, user management, level setting, as well as parameter setting within a system (the last case involves those non-protocol or non RFC provisioned commands).

Login users are also classified into four levels that correspond to the four command levels. After users at different levels log in, they can only use commands at their own, or lower, levels.

Note that:

Users can switch to a lower user level unconditionally. To log in through AUX, TTY, or VTY user interface and switch to a higher user level, however, they need to enter the password (The password can be set with the super password command.). If the entered password is incorrect or no password is configured, the switch fails. Therefore, before switching to a higher user level, users should configure the password needed.

Related command: super password.

Example # Set the user level to 2 (the current user level is 3).

<Sysname> super 2

User privilege level is 2, and only those commands can be used whose level is equal or less than this.

Privilege note: 0-VISIT, 1-MONITOR, 2-SYSTEM, 3-MANAGE

# Switch the user level back to 3 (Suppose password 123 has been set; otherwise, the user level cannot be switched to 3.).

<Sysname> super 3 Password:

User privilege level is 3, and only those commands can be used whose level is equal or less than this.

super password

Syntax	super password [ level user-level] { simple cipher } password
	undo super password [ level user-level]
View	System view
Parameter	level user-level: Specifies user level. The user-levelargument ranges from 1 to 3
	and defaults to 3.
	simple: Plain text password.