3Com MSR 30 Menu hotkey, Menu screencode, Syntax menu hotkey ascii-code&1-3 Undo menu hotkey

908CHAPTER 70: TERMINAL ACCESS CONFIGURATION COMMANDS

menu hotkey

Syntax menu hotkey ascii-code&<1-3>

undo menu hotkey

View Terminal template view

Parameters ascii-code&<1-3>: ASCII value of hotkey, ranging 1 to 255. “&<1-3>” means that you can provide up to three hotkey ASCII values.

Description Use the menu hotkey command to configure the menu hotkey.

Use the undo menu hotkey command to cancel the menu hotkey configured.

By default, no menu hotkey is configured.

If the current terminal operates on the service interface, you can switch to the menu interface by entering the menu hotkey configured.

RTC terminal access does not support the menu function.

Note:

■The ASCII value of the hotkey must be different from that of any other hotkey configured on the device. Otherwise, hotkey conflicts will occur. For example, the hotkey value cannot be set to 17 or 19 because these two values are used for the hotkeys of flow control.

■Using the hotkey may not get a response rapidly when the terminal displays too much data.

■Before using this command, make sure you enable the router to print characters to the terminal and enable menu printing.

Related command: print information and print menu.

Example # Configure the hotkey for switching to the menu as <Alt+A>, whose corresponding ASCII codes are a combination of 1, 96, and 13.

<Sysname> system-view

[Sysname] rta template abc

[Sysname-rta-template-abc] menu hotkey 1 96 13

menu screencode

Syntax menu screencode string

undo menu screencode

View Terminal template view