43-732.fm Page 29 Friday, August 13, 1999 1:42 PM

REMOTE OPERATION

While you are away from your home or office, you can use a touch-tone phone or a pulse (rotary) phone with a pocket tone dialer to enter your remote opera- tion security code and do any of the fol- lowing:

set the TAD to answer calls

listen to messages

record a new outgoing message

record a memo

delete messages

Note: You cannot operate the TAD from another phone on the same line as your TAD-732.

1.Dial your phone number. After about 10 rings, the TAD automatically turns on to answer your call and an- nounces “Answer off.”

2.Enter your remote operation securi- ty code. The TAD beeps.

Note: If you do not enter each digit of the security code within 20 sec- onds, the TAD hangs up.

3.Press then . The TAD says “An- swer on” and beeps twice. It is now set to record calls.

At this point you can hang up or enter other remote commands.

USING TOLL-SAVER

If the 4/7/TS switch is set to TS (toll- saver, see “Setting the Number of Rings” on Page 15), the TAD answers after about two rings if you have new messages. If there are no new messag- es, the TAD waits for about four rings before it answers. This gives you time to hang up before the TAD answers so you can avoid unnecessary long-distance charges.

USING REMOTE

ANSWER-ON

Follow these steps to remotely set the TAD to answer calls.

USING REMOTE

COMMANDS

Follow these steps to operate the TAD from a remote touch-tone phone.

1.Dial your phone number and wait for the TAD to answer.

2.When the outgoing message be- gins, enter your 2-digit remote oper- ation security code. The TAD beeps twice to let you know you entered the code correctly.

3.Enter the code for the desired re- mote command (see “Remote Com- mands” on Page 30).

4.When you finish, simply hang up.

Note: If you wait more than 20 seconds without entering a command, the TAD hangs up.

29

Page 29
Image 29
Radio Shack TAD-732 owner manual Remote Operation, Using TOLL-SAVER, Using Remote ANSWER-ON, Using Remote Commands