Radio Shack TAD-732 owner manual Deleting Messages, Changing the Remote Operation Security Code

43-732.fm Page 28 Friday, August 13, 1999 1:42 PM

DELETING MESSAGES

To delete the current message during playback, press DELETE on the base or handset.

Note: You can replay a deleted mes- sage by repeatedly pressing REPEAT on the base or handset before the TAD an- nounces “End of messages.”

To delete all messages in a mailbox or the message center after playback, press DELETE then the mailbox or mes- sage center button. The TAD beeps.

Note: The TAD-732 does not delete un- played messages.

CHANGING THE REMOTE OPERATION SECURITY CODE

To use your TAD from a remote tele- phone, you must first enter a 2-digit re- mote operation security code. The security code for your TAD is preset to

28

50.You can use the preset code, or fol- low these steps to change it.

Note: In Step 2 you must begin entering the new code within 20 seconds. Other- wise, the TAD sounds 5 short beeps and 2 long beeps and stops the process. If this happens, simply repeat Step 2.

1.Press REMOTE on the handset. The REMOTE indicator lights.

REMOTE Indicator

2.Press CHANGE () then CODE (7). The TAD announces “Enter new code.” Enter a new two-digit remote operation security code. The TAD announces “New code is xx” and beeps twice.

3.Press REMOTE. The REMOTE indi- cator turns off.

To check the remote operation security code, press REMOTE then CODE. The TAD announces “Code is xx” and beeps twice.