1. Drill two holes 315/16 | 3/16" |
inches (100 mm) |
|
apart. Then thread a |
|
screw into each hole, |
|
letting the heads ex- |
|
tend about 3/16 inch (5 |
|
mm) from the wall. | 315/16" |
2.Remove the mounting bracket by holding in both tabs and gently pull- ing out the wide end of the bracket.
3.Plug one end of the supplied long modular cord into the telephone jack on the back of the base.
4.Insert the supplied AC adapter’s barrel plug into the DC 9V jack on the back of the base.
5.Route the modular cord through the groove below the strain relief slot and the adapter cord through the left groove on the bottom of the base.
Strain
Relief
Slot
6.Insert the tabs on the narrow end of the bracket into the inner pair of slots near the top of the base as shown and snap the tabs at the wide end of the bracket into place.
11
