3Com MSR 30, MSR 50 manual Load-bandwidth, Reset load-sharing

950CHAPTER 71: IP ROUTING TABLE COMMANDS

load-bandwidth

Syntax load-bandwidth bandwidth

undo load-bandwidth

View Interface view

Parameters bandwidth: Specifies the load sharing bandwidth for the interface.

Description Use the load-bandwidthbandwidth command to specify the load sharing bandwidth of the interface.

Use the undo load-bandwidthcommand to restore the default.

The load sharing bandwidth of an interface defaults to the physical bandwidth of the interface.

Examples # Configure the load sharing bandwidth of the interface.

<Sysname> system-view

[Sysname] interface ethernet 1/0

[Sysname-Ethernet1/0] load-bandwidth 100

reset load-sharing

Syntax reset load-sharing statistics ip address ip-address { mask mask-length }

reset load-sharing statistics all

View User view

Parameters ip-address: Destination IP address, in dotted decimal notation.

mask: IP address mask, in dotted decimal notation.

mask-length:IP address mask length, in the range 0 to 32.

Description Use the reset load-sharing ip address command to clear the statistics of non-balanced load sharing. This command clears the load sharing statistics of all the outbound interfaces corresponding to the destination IP address.

Use the reset load-sharing all command to clear the load sharing statistics of the outbound interfaces of all the forwarding entries.

Examples # Display the statistics of bandwidth-based load sharing.

<Sysname> display load-sharing ip address 10.2.1.0 24

There are/is totally 3		route entry(s) to the same destination			network.
Nexthop	Packet(s)	Bandwidth[KB]	Flow(s)	Interface
10.1.1.2	763851	100000	0	Ethernet0/0/0