666CHAPTER 44: LOGICAL INTERFACE CONFIGURATION COMMANDS

Description Use the interface ethernet command to create an Ethernet sub-interface and enter the corresponding Ethernet sub-interface view.

Use the undo interface ethernet command to remove the specified Ethernet sub-interface.

By default, no VLAN is associated to an Ethernet sub-interface.

Note that the VLAN associated with the Ethernet sub-interface of the local device must be the same as the VLAN associated to the Ethernet sub-interface of the peer device. Otherwise, packets cannot be transmitted properly. A Layer 3 Ethernet interface can accommodate 1 to 4,096 sub-interfaces.

Example # Create a sub-interface on Ethernet 1/0.

<Sysname> system-view

[Sysname] interface ethernet 1/0.1

[Sysname-Ethernet1/0.1]

interface loopback

Syntax interface loopback number

undo interface loopback number

View System view

Parameter number: Loopback interface number, ranging from 0 to 1023.

Description Use the interface loopback command to create a Loopback interface and enter the corresponding Loopback interface view.

Use the undo interface loopback command to remove the specified Loopback interface.

Related command: display interface loopback.

Example # Create Loopback 5.

<Sysname> system-view

[Sysname] interface loopback 5

[Sysname-LoopBack5]

interface mfr

Syntax interface mfr { interface-number interface-number.subnumber }

undo interface mfr { interface-number interface-number.subnumber }

View System view

Page 666
Image 666
3Com MSR 30, MSR 50 manual Interface loopback, Related command display interface loopback, Example # Create Loopback