3Com MSR 30, MSR 50 manual Signal-value, Special-character, Related command Subscriber line Example

2668 CHAPTER 175: E1 AND T1 CONFIGURATION COMMANDS

	<Sysname> system-view
	[Sysname] controller e1 1/0
	[Sysname-e1 1/0] timeslot-set 5 timeslot-list 1-31 signal r2
	[Sysname-e1 1/0] cas 5
	[Sysname-cas1/0:5] sendring ringbusy enable
signal-value
Syntax	signal-value { received idle received seize transmit idle transmit seize } ABCD
	undo signal-value { received idle received seize transmit idle transmit seize }
View	Digital E&M voice subscriber line view
Parameter	received idle: Indicates the receive idle signal of digital E&M signaling.
	received seize: Indicates the receive seized signal of digital E&M signaling.
	transmit idle: Indicates the transmit idle signal of digital E&M signaling.
	transmit seize: Indicates the transmit seized signal of digital E&M signaling.
	ABCD: Default ABCD bit pattern during transmission, with each bit taking the
	value of 0 or 1.
Description	Use the signal-valuecommand to configure the ABCD bit patterns of idle
	receive, receive seized, idle transmit, and transmit seized signals on the digital
	E&M voice subscriber line.
	Use the undo signal-valuecommand to restore the defaults.
	By default, the ABCD bit patterns of the receive idle signal and the transmit idle
	signal are 1101, and the ABCD bit patterns of the receive seized signal and the
	transmit seized signal are 0101. After changing the ABCD bit pattern of a digital
	E&M signal, you must shut down the digital E&M subscriber line with the
	shutdown command and then bring the line up with the undo shutdown
	command. Otherwise, the voice subscriber line cannot work normally.
Related command:	subscriber line.
Example	# Set the ABCD bit pattern to 1011 for the transmit seized signal on digital E&M
	subscriber line 1/0:0.
	<Sysname> system-view
	[Sysname] voice-setup
	[Sysname-voice] subscirber-line1/0:0
	[Sysname-voice-line1/0:0] signal-value transmit seize 1011
special-character

Syntax special-character character number