3Com MSR 30, MSR 50 manual Keepalive interval, Related command vam server vpn, keepalive retry

1726 CHAPTER 99: VAM SERVER CONFIGURATION COMMANDS

public-ip-address: Public IP address of Hub.

Description Use the hub private-ipcommand to specify the IP address of Hub.

Use the undo hub private-ipcommand to remove the IP address of the specified Hub.

By default, no Hub IP address is configured.

Note that:

■You can specify only the private IP address of Hub. When Hub is added to a VPN domain, the VAM server can obtain the mapping information between the registered public and private addresses of the Hub.

■Currently, up to two Hub addresses can be configured on the VAM server.

Related command: vam server vpn.

Example # Specifies in VPN 1 the public and private IP addresses of Hub as 123.0.0.1 and 10.1.1.1 respectively.

<Sysname> system-view [Sysname] vam server vpn 1

[Sysname-vam-server-vpn-1] hub private-ip 10.1.1.1 public-ip 123.0.0.1

keepalive interval

Syntax keepalive interval time-interval

undo keepalive interval

View VPN domain view

Parameter time-interval: Interval for sending keepalive message from VAM client. It is in the range 5 to 60 seconds.

Description Use the keepalive interval command to configure the interval for sending keepalive messages from VAM client to VAM server.

Use the undo keepalive interval command to restore to the default value.

By default, the interval for sending keepalive message from VAM client is 10 seconds.

Note that the VAM server sends this setting in a registration response to its clients. All clients in a VPN have the same keepalive settings, but if you change the keepalive settings of the server, the new settings are sent to only clients that register later; all clients registering before use the old settings.

Related command: vam server vpn, keepalive retry